Hi Cyril, Which model do you have? And check the corresponding board file if card detect GPIO handling is doing right.
- eric On Tue, Apr 12, 2011 at 11:15 PM, Cyril Hrubis <me...@ucw.cz> wrote: > Hi! > When I insert the mmc card to zaurus, it gets properly detected and prints > some > info into console. Mounting reading/writing files works fine. > > However when the card is removed (doesn't need to be mounted before), the > removal is most likely not detected, so when I insert it again, no info is > printed into console and moreover when I try to mount it zaurus goes into > infinite loop printing: > > Buffer I/O error on device mmcblk0p1, logical block 9 > mmcblk0: error -110 sending status command > mmcblk0: error -110 sending read/write command, response 0xb00, card status > 0xb00 > end_request: I/O error, dev mmcblk0, sector 257 > Buffer I/O error on device mmcblk0p1, logical block 10 > mmcblk0: error -110 sending status command > mmcblk0: error -110 sending read/write command, response 0xb00, card status > 0xb00 > end_request: I/O error, dev mmcblk0, sector 258 > Buffer I/O error on device mmcblk0p1, logical block 11 > mmcblk0: error -110 sending status command > mmcblk0: error -110 sending read/write command, response 0xb00, card status > 0xb00 > end_request: I/O error, dev mmcblk0, sector 259 > Buffer I/O error on device mmcblk0p1, logical block 12 > mmcblk0: error -110 sending status command > mmcblk0: error -110 sending read/write command, response 0xb00, card status > 0xb00 > ... > > Related part of the .config: > > # > # OTG and related infrastructure > # > # CONFIG_USB_GPIO_VBUS is not set > # CONFIG_USB_ULPI is not set > # CONFIG_NOP_USB_XCEIV is not set > CONFIG_MMC=y > # CONFIG_MMC_DEBUG is not set > CONFIG_MMC_UNSAFE_RESUME=y > # CONFIG_MMC_CLKGATE is not set > > # > # MMC/SD/SDIO Card Drivers > # > CONFIG_MMC_BLOCK=y > CONFIG_MMC_BLOCK_MINORS=8 > CONFIG_MMC_BLOCK_BOUNCE=y > # CONFIG_SDIO_UART is not set > # CONFIG_MMC_TEST is not set > > # > # MMC/SD/SDIO Host Controller Drivers > # > CONFIG_MMC_PXA=y > > -- > metan > _______________________________________________ Zaurus-devel mailing list Zaurus-devel@lists.linuxtogo.org http://lists.linuxtogo.org/cgi-bin/mailman/listinfo/zaurus-devel
