I can say sth similar about:
Bus 001 Device 004: ID 079b:0062 Sagem
After adding its id to the list of supported devices in the code of zd1211rw
it worked (I had no other device to test it with, but scanning has shown
some nets).
If you are interested I can investigate it further on monday.
This device is added to 'LiveBox' (a device, packet, service of wireless
netaccess in Poland...).
Driver zd1211b had problems on this computer. I will post another message
concerning this problems and how i fixed them...
[21:12:00] Cirrus
/lib/modules/2.6.18-gentoo-r1-bla/kernel/drivers/net/wireless/zd1211rw #
dmesg
usb 1-1: new full speed USB device using uhci_hcd and address 5
usb 1-1: configuration #1 chosen from 1 choice
ieee80211_crypt: registered algorithm 'NULL'
ieee80211: 802.11 data/management/control stack, git-1.1.13
ieee80211: Copyright (C) 2004-2005 Intel Corporation
<[EMAIL PROTECTED]>
usb_init()
usb 1-1: print_id() 079b:0062 v4810 full
zd1211rw 1-1:1.0: zd_netdev_alloc() netdev->flags 0x1002
zd1211rw 1-1:1.0: zd_netdev_alloc() netdev->features 0x00000000
usb 1-1: request_fw_file() fw name zd1211/zd1211b_ub
usb 1-1: upload_firmware() firmware device id 0x4810 is equal to the actual
device id
usb 1-1: request_fw_file() fw name zd1211/zd1211b_uphr
usb 1-1: upload_code() transfer size 4096
usb 1-1: upload_code() transfer size 1024
usb 1-1: upload_code() firmware confirm return value 0x01
zd1211rw 1-1:1.0: zd_usb_enable_int()
zd1211rw 1-1:1.0: zd_usb_enable_int() submit urb d6a3a340
zd1211rw 1-1:1.0: zd_chip_init_hw()
zd1211rw 1-1:1.0: dump_cr() CR_AFTER_PNP 0x00000000
zd1211rw 1-1:1.0: dump_cr() CR_GPI_EN 0x00000000
zd1211rw 1-1:1.0: dump_cr() CR_INTERRUPT 0x00000000
zd1211rw 1-1:1.0: zd_usb_init_hw() fw_base_offset: 0xf7c9
zd1211rw 1-1:1.0: read_pod() E2P_POD 0x00000184
zd1211rw 1-1:1.0: read_pod() RF AL2230_RF 0x4 PA type 0x0 patch CCK 1 patch
CR157 0 patch 6M 0
zd1211rw 1-1:1.0: hw_init()
zd1211rw 1-1:1.0: zd1211b_hw_reset_phy()
zd1211rw 1-1:1.0: zd_chip_lock_phy_regs() CR_REG1: 0x00 -> 0x00
zd1211rw 1-1:1.0: zd_chip_unlock_phy_regs() CR_REG1: 0x00 -> 0x80
zd1211rw 1-1:1.0: zd1211b_hw_init_hmac()
zd1211rw 1-1:1.0: get_aw_pt_bi() aw 0 pt 0 bi 0
zd1211rw 1-1:1.0: set_aw_pt_bi() aw 0 pt 99 bi 100
zd1211rw 1-1:1.0: zd_chip_lock_phy_regs() CR_REG1: 0xa0 -> 0x20
zd1211rw 1-1:1.0: zd_usb_rfwrite() value 0x003f790 bits 24
zd1211rw 1-1:1.0: zd_usb_rfwrite() value 0x0033331 bits 24
zd1211rw 1-1:1.0: zd_usb_rfwrite() value 0x000000d bits 24
zd1211rw 1-1:1.0: zd_usb_rfwrite() value 0x00b3331 bits 24
zd1211rw 1-1:1.0: zd_usb_rfwrite() value 0x003b812 bits 24
zd1211rw 1-1:1.0: zd_usb_rfwrite() value 0x000fff3 bits 24
zd1211rw 1-1:1.0: zd_usb_rfwrite() value 0x00005a4 bits 24
zd1211rw 1-1:1.0: zd_usb_rfwrite() value 0x00f4dc5 bits 24
zd1211rw 1-1:1.0: zd_usb_rfwrite() value 0x00805b6 bits 24
zd1211rw 1-1:1.0: zd_usb_rfwrite() value 0x00146c7 bits 24
zd1211rw 1-1:1.0: zd_usb_rfwrite() value 0x0000688 bits 24
zd1211rw 1-1:1.0: zd_usb_rfwrite() value 0x00403b9 bits 24
zd1211rw 1-1:1.0: zd_usb_rfwrite() value 0x000dbba bits 24
zd1211rw 1-1:1.0: zd_usb_rfwrite() value 0x000099b bits 24
zd1211rw 1-1:1.0: zd_usb_rfwrite() value 0x00bdffc bits 24
zd1211rw 1-1:1.0: zd_usb_rfwrite() value 0x000000d bits 24
zd1211rw 1-1:1.0: zd_usb_rfwrite() value 0x000580f bits 24
zd1211rw 1-1:1.0: zd_usb_rfwrite() value 0x000880f bits 24
zd1211rw 1-1:1.0: zd_usb_rfwrite() value 0x000080f bits 24
zd1211rw 1-1:1.0: zd_usb_rfwrite() value 0x000d80f bits 24
zd1211rw 1-1:1.0: zd_usb_rfwrite() value 0x000780f bits 24
zd1211rw 1-1:1.0: zd_usb_rfwrite() value 0x000580f bits 24
zd1211rw 1-1:1.0: zd_chip_unlock_phy_regs() CR_REG1: 0x20 -> 0xa0
zd1211rw 1-1:1.0: firmware version 4725
zd1211rw 1-1:1.0: dump_fw_registers() FW_FIRMWARE_VER 0x4725
zd1211rw 1-1:1.0: dump_fw_registers() FW_USB_SPEED 0x0000
zd1211rw 1-1:1.0: dump_fw_registers() FW_FIX_TX_RATE 0x0000
zd1211rw 1-1:1.0: dump_fw_registers() FW_LINK_STATUS 0x0000
zd1211rw 1-1:1.0: dump_cr() CR_AFTER_PNP 0x00000001
zd1211rw 1-1:1.0: dump_cr() CR_GPI_EN 0x00000000
zd1211rw 1-1:1.0: dump_cr() CR_INTERRUPT 0x00000000
zd1211rw 1-1:1.0: zd1211b chip 079b:0062 v4810 full 00-60-b3 AL2230_RF pa0
g--
zd1211rw 1-1:1.0: zd_write_mac_addr() mac addr 00:60:b3:44:1e:8e
zd1211rw 1-1:1.0: zd_read_regdomain() regdomain: 0x30
zd1211rw 1-1:1.0: regdomain 0x30
zd1211rw 1-1:1.0: zd_usb_disable_int() urb d6a3a340 killed
zd1211rw 1-1:1.0: probe() successful
zd1211rw 1-1:1.0: eth1
usbcore: registered new driver zd1211rw
zd1211rw initialized
eth1 802.11g zd1211 ESSID:off/any
Mode:Managed Access Point: Invalid
Encryption key:off
Link Quality:0 Signal level:0 Noise level:0
Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
Tx excessive retries:0 Invalid misc:0 Missed beacon:0
--
View this message in context:
http://www.nabble.com/new-hardware-tested-with-zd1211rw-tf2632782.html#a7410191
Sent from the zd1211-devs mailing list archive at Nabble.com.
-------------------------------------------------------------------------
Take Surveys. Earn Cash. Influence the Future of IT
Join SourceForge.net's Techsay panel and you'll get the chance to share your
opinions on IT & business topics through brief surveys - and earn cash
http://www.techsay.com/default.php?page=join.php&p=sourceforge&CID=DEVDEV
_______________________________________________
Zd1211-devs mailing list - http://zd1211.ath.cx/
Unsubscribe: https://lists.sourceforge.net/lists/listinfo/zd1211-devs
