Giuseppe Lippolis wrote: > so i execute > iwconfig eth1 essid "********" > > an then iwconfig > eth1 IEEE 802.11b/g ESSID:"********" Nickname:"zd1211" > Mode:Managed Frequency:2.412 GHz Access Point: 00:0F:3D:A6:FA:DA > Bit Rate=1 Mb/s > Encryption key:off > Link Quality:0 Signal level:0 Noise level:0 > Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0 > Tx excessive retries:0 Invalid misc:0 Missed beacon:0 > > but after 2 second if i execute : > eth1 IEEE 802.11b/g ESSID:"********" Nickname:"zd1211" > Mode:Managed Frequency:2.412 GHz Access Point: Invalid > Bit Rate=1 Mb/s > Encryption key:off > Link Quality:0 Signal level:0 Noise level:0 > Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0 > Tx excessive retries:0 Invalid misc:0 Missed beacon:0 > > The interface seems to not work properly.
Enable softmac debugging in your kernel and post kernel logs from after the failure. Also run "iwevent" in parallel and post the messages from that too. Daniel ------------------------------------------------------------------------- This SF.net email is sponsored by DB2 Express Download DB2 Express C - the FREE version of DB2 express and take control of your XML. No limits. Just data. Click to get it now. http://sourceforge.net/powerbar/db2/ _______________________________________________ Zd1211-devs mailing list - http://zd1211.wiki.sourceforge.net/ Unsubscribe: https://lists.sourceforge.net/lists/listinfo/zd1211-devs
