On Dec 21, 2007 6:22 AM, Daniel Drake <[EMAIL PROTECTED]> wrote:
> Bryan Donlan wrote:
> > I've retried using 2.6.23.12 (and this time I remembered to install
> > the firmware), but still no go. I've attached dmesg with SoftMAC and
> > zd1211rw debug on full. Again I'm able to scan for networks (although
> > some show as essid="<hidden>", the one I'm trying to connect to shows
> > up properly), but I can't associate. wavemon shows 0 for RX and all
> > signal levels.
>
> It's not clear what's going wrong, there does not seem to be any
> response to the association request. As the next step you could try the
> vendor driver, or you could run another wireless device in monitor mode
> and watch the traffic. Is the association request from the device
> "hitting the air"? Is the access point sending an association response
> to the device?
Hi,
The tests before I performed on my school's open wireless network. I'm
now at home, where we have a WEP-secured network. In this case the
network isn't even appearing in a scan; I just get:
eth2 Scan completed :
Cell 01 - Address: 00:0F:3D:37:FB:02
ESSID:""
Protocol:IEEE 802.11bg
Mode:Master
Frequency:2.437 GHz (Channel 6)
Encryption key:on
Bit Rates:1 Mb/s; 2 Mb/s; 5.5 Mb/s; 9 Mb/s; 11 Mb/s
6 Mb/s; 12 Mb/s; 18 Mb/s; 24 Mb/s; 36 Mb/s
48 Mb/s; 54 Mb/s
Quality=100/100 Signal level=58/100
Extra: Last beacon: 259ms ago
The access point address and channel are correct, but the ESSID is blank there.
Also, how would one put another device into monitor mode? It'd have to
be something I can use from a livecd...
Thanks,
Bryan Donlan
-------------------------------------------------------------------------
This SF.net email is sponsored by: Microsoft
Defy all challenges. Microsoft(R) Visual Studio 2005.
http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/
_______________________________________________
Zd1211-devs mailing list - http://zd1211.wiki.sourceforge.net/
Unsubscribe: https://lists.sourceforge.net/lists/listinfo/zd1211-devs
