This thread might be helpful: http://community.zenoss.com/forums/viewtopic.php?t=3578&highlight=interface+speed
I had the same problem last year - I am pretty sure I simply made some local copies of templates where it was an issue, and then did some manual modifications. Hope this helps! -Kris >>> "markraves" <[EMAIL PROTECTED]> 4/11/2008 08:05 >>> Hello, I'm running zenoss against several products. All my cisco and hp equip. registers nicely on ifspeed. However, I also have several allied telesyn rg's, apc management cards, and alcatel dslam's that zenoss can't find the interface speed on. This results in several stupid messages about exceeding 75% of max speed with little / less traffic. And I don't like it. Is there a way you can modify the interfaces more or less directly? So I can tell zenoss that it is 100mbit? Thanks \\markraves -------------------- m2f -------------------- Read this topic online here: http://community.zenoss.com/forums/viewtopic.php?p=18407#18407 -------------------- m2f -------------------- _______________________________________________ zenoss-users mailing list [email protected] http://lists.zenoss.org/mailman/listinfo/zenoss-users _______________________________________________ zenoss-users mailing list [email protected] http://lists.zenoss.org/mailman/listinfo/zenoss-users
