Is there anything in the zenmodeler.log that is throwing an error?
Thanks,
Matt Ray
Zenoss Community Manager
community.zenoss.com
[EMAIL PROTECTED]
On Aug 28, 2008, at 6:45 PM, andrewhead wrote:
[quote="mray"]If it is the same IP and same hostname, zenmodeler
should pick up the
device information changes when it runs.
Matt,
That's what I had hoped was going to happen. However, I recently
replaced several Cisco 3550-24 PWR switches with 3524XL switches but
Zenoss has not detected the change.
I have verified that Zenoss can tell the difference between the two
oids for these specific switch models, but alas, even when modeling
them manually through the menu it does not detect the change.
Any suggestion on where to begin troubleshooting a problem like this?
Much Appreciated.
Andrew.
-------------------- m2f --------------------
Read this topic online here:
http://community.zenoss.com/forums/viewtopic.php?p=24431#24431
-------------------- m2f --------------------
_______________________________________________
zenoss-users mailing list
[email protected]
http://lists.zenoss.org/mailman/listinfo/zenoss-users
_______________________________________________
zenoss-users mailing list
[email protected]
http://lists.zenoss.org/mailman/listinfo/zenoss-users
