Well... I know the install notes say to be patient, but its been about 3 hrs and I still don't have a single point plotted.
Also when I look at /Reports /Performance Reports /Interface Utilization I see this. Device Interface Speed Input Output Total % Util location 1 WAN 1 1.5MB nanPB nanPB nanPB nan location 2 eth0 100.0MB nanPB nanPB nanPB nan location 3 eth1 100.0MB nanPB nanPB nanPB nan location 1 Eth0 10.0MB nanPB nanPB nanPB nan location 2 eth1 100.0MB nanPB nanPB nanPB nan location 3 eth0 100.0MB nanPB nanPB nanPB nan Now I know the devices are correctly sending out SNMP data. I can view and monitor bandwidth reports via the PRTG Traffic Grapher. I am running this on a mac and I seem to be able to add devices/locations with no difficulty. The only thing that does not seem to be functioning is the reports... Have tried a bit of searching but any help, even if it is just a link to a forum post would be greatly appreciated. Thanks, Mark Reynolds -------------------- m2f -------------------- Read this topic online here: http://forums.zenoss.com/viewtopic.php?p=33268#33268 -------------------- m2f -------------------- _______________________________________________ zenoss-users mailing list [email protected] http://lists.zenoss.org/mailman/listinfo/zenoss-users
