Do you get graphs in a devices perf tab, and not in the report? It looks like it's failing to grab the data. Can you SNMP walk the device/OIDs from the Zenoss server? -- James Pulver Information Technology Area Supervisor LEPP Computer Group Cornell University
markeriv wrote, On 4/9/2009 5:50 PM: > Well... I know the install notes say to be patient, but its been about 3 hrs > and I still don't have a single point plotted. > > Also when I look at /Reports /Performance Reports /Interface Utilization I > see this. > > Device Interface Speed Input Output Total % Util > location 1 WAN 1 1.5MB nanPB nanPB nanPB nan > location 2 eth0 100.0MB nanPB nanPB nanPB nan > location 3 eth1 100.0MB nanPB nanPB nanPB nan > location 1 Eth0 10.0MB nanPB nanPB nanPB nan > location 2 eth1 100.0MB nanPB nanPB nanPB nan > location 3 eth0 100.0MB nanPB nanPB nanPB nan > > Now I know the devices are correctly sending out SNMP data. I can view and > monitor bandwidth reports via the PRTG Traffic Grapher. > > I am running this on a mac and I seem to be able to add devices/locations > with no difficulty. The only thing that does not seem to be functioning is > the reports... > > Have tried a bit of searching but any help, even if it is just a link to a > forum post would be greatly appreciated. > > Thanks, > Mark Reynolds > > > > > -------------------- m2f -------------------- > > Read this topic online here: > http://forums.zenoss.com/viewtopic.php?p=33268#33268 > > -------------------- m2f -------------------- > > > > _______________________________________________ > zenoss-users mailing list > [email protected] > http://lists.zenoss.org/mailman/listinfo/zenoss-users _______________________________________________ zenoss-users mailing list [email protected] http://lists.zenoss.org/mailman/listinfo/zenoss-users
