Thanks for that. Success. I was apprehensive about prying too hard. Tony On Dec 12, 2011, at 11:53 AM, Edmund White wrote:
> You need to pry the drive sled off of the disk once the screws are > removed. There are two or four notches that hold onto the disk. You'll end > up spreading the carrier frame slightly. > > -- > Edmund White > [email protected] > > > > > On 12/12/11 5:25 PM, "Tony Schreiner" <[email protected]> wrote: > >> Sorry for the off-topic question. >> I'm needing to replace a disk in a x4540 zfs file system. I have >> replacement ST31000NSSUN disks, but it's not obvious to me how to >> separate the original disk from its drive sled, it seems to be attached >> by more than the usual 4 screws. Is it meant to be separated? I've looked >> the x4540 user guide but it does not say anything about it. >> >> Tony Schreiner >> _______________________________________________ >> zfs-discuss mailing list >> [email protected] >> http://mail.opensolaris.org/mailman/listinfo/zfs-discuss > _______________________________________________ zfs-discuss mailing list [email protected] http://mail.opensolaris.org/mailman/listinfo/zfs-discuss
