see if you can upgrade to firmware 4-3 or 4-4 another point to note, are you using a full duplex 10/100 switch? if so, you should have 'Port1 Full 100' for full duplex 100Mbit under the 'Network Statistics'
If you like to email me your config settings, I will check them against our phones. telnet to the phone, and capture 'Phone> show config' Doug Terence Parker wrote: > Thanks for the replies. > > My cisco firmware is only POS3-04-2-00, though it is SIP. It used to work > fine under vocal though - which was strange. Is this definitely nothing to > do with asterisk? I do note however that my firmware is fairly old... except > cisco aren't exactly generous with firmware upgrades. > > I have tried both g729a (default on my phone) and g711ulaw with no success. > But i'll have another fiddle and try to get it to work. > > Thanks again. > > Terence > > > what firmware are you using? is it SIP? > > to check, push settings then status and firmware > > you should have a load ID like this 'POS3-04-4-00' > > also check the preferred CODEC > > we use g711ulaw as the default > > -- snip -- > > > You must be doing something wrong (maybe codec problems), because I've > > had absolutely no problems with Cisco to Cisco calls, and I've got > > almost 50 deployed across the company. (For what it's worth, I'm using > > the "ulaw" codec.) > > > > Jared Smith > > _______________________________________________ > Asterisk-Users mailing list > [EMAIL PROTECTED] > http://lists.digium.com/mailman/listinfo/asterisk-users -- FREE Unlimited Worldwide Voip calling set-up an account and start saving today! http://www.voippages.com ext. 7000 http://www.pulver.com/fwd/ ext. 83740 free IP phone software @ http://www.xten.com/ http://iaxclient.sourceforge.net/iaxcomm/ _______________________________________________ Asterisk-Users mailing list [EMAIL PROTECTED] http://lists.digium.com/mailman/listinfo/asterisk-users