Re: [Moblin Dev] Developer Moblin2 image

[Rusty Lynch]

On Fri, 2009-05-01 at 10:51 -0700, Hernandez, Eli wrote:
> MoblinFans,
> 
> I've successfully installed the Moblin Developer image booted from a live 
> (developer) image onto another thumb drive with instructions below.
> Installation target thumb drive must be >8GB. When installation creates the 
> disk layout on target drive, review partitions and write device names down 
> the "/" and "/boot" filesystems.
> In my particular case, "/" was assigned to /dev/sdb2 and "/boot" to 
> /dev/sdb1, respectively. I then mounted these according to the instructions 
> below to make the small config changes - now I have a very portable Moblin 
> development system.
> 
> On a separate note, I'm observing an issue configuring pyclutter. It 
> complains about the installed pygtk-2.0 not being the correct version. I used 
> yum to pull in and install pygtk-2.13.1 and when I try to configure pyclutter 
> it complains about pygtk-2.0 >= 2.8.0 requirement not being met. If I go back 
> to pygtk v2.8.0 then a whole set of new issues arise where even the 
> "developer Moblin image" included clutter v0.9.2 image does not meet reqs for 
> pyclutter.
> 
> If anyone has worked around the pyclutter issue as I described, I would most 
> grateful if solution is shared.

Looks like you stumbled across a packaging issue. Please file a bug in
bugzilla.moblin.org so the distro team will not drop this.

    --rusty

_______________________________________________
Moblin dev Mailing List
dev@moblin.org

To manage or unsubscribe from this mailing list visit:
https://lists.moblin.org/mailman/listinfo/dev or your user account on 
http://moblin.org once logged in.

For more information on the Moblin Developer Mailing lists visit:
http://moblin.org/community/mailing-lists