My Christmas project of the K2 build got started early (s/n 4539). Here are the two problems I have right now:
* Display LCD (i.e. text readout) is very dim. It's almost impossible to read with the backlight off. Everything displays as normal, but just very dim text. (The LED backlight comes right on and is great.) * When adjusting the pot on the control board (R1) for 3.80V per the alignment procedure during the checkout of the control board and display board, the most I can get is 3.6V. The measured and reported supply voltage is 14.7-14.8V and the current draw varies between 80 and 100 mA. Yes, I've checked the solder joints. First item I looked at. I was using a pretty bad DMM (since I started the build much sooner than I planned, I didn't have everything with me) but I *think* the resistance checks were all normal (I'm stealing a better DMM from work this weekend). Thanks in advance, tim -- Tim Cailloux [EMAIL PROTECTED] W4EGT _______________________________________________ Elecraft mailing list Post to: Elecraft@mailman.qth.net You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
