I recently finished my KX-1 and installed the ATU board only to find that my ouput is only about 0.9 watts on 40 and 0.2 on 20. When I finished the basic KX-1, I put it on an uncalibrated QRP wattmeter and it read about 2 watts, so I thought I was in the ballpark. Now, assuming that my original 2 watt reading is really 0.9, I find that the output is the same both with and without the ATU, so the problem must be in the transmitter and not the ATU.
The KX-1 checked out fine through stages 1 and 2 and the resistance readings for stage 3 were all OK. I just checked the voltages on Q4, Q5 and Q6 and they are within 10% of the table. I've checked the continuity for all the toroids and T1, as well and recounting the turns and lead placement. The output control is fully clockwise and the output is being fed into a 50 ohm dummy load. All control functions appear to be working correctly and the receiver seems to be normal on all the bands. I'm at a loss and could use a healthy does of "elecraft mojo" Thanks, John WA8FNJ _______________________________________________ Elecraft mailing list Post to: Elecraft@mailman.qth.net You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
