I am utilizing FW vers. 1.02 and connecting to the K3 via the aux bus cable. If I set the KPA500 "PWR ON" menu setting to OPER, the K3 will not show the "KPA500 OPER" on the display and apprently is not syncing. In that state, if I transmit, the amp will immediately go into a Hi Pwr fault. (no matter how long I wait for the aux bus cable to sync).
If ,However, I set the PWR ON menu default to STBY and manually switch to OPER, the K3 will properly sync and will display "KPA500 OPER" and all is well. Could this be a firmware issue? Any suggestions? Tnx Len ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html