Wow you guys are good! Heh, can't believe I missed that, but then again I build better than I diagnose! It was L2. No continuity at all. I checked the other inductors and they are fine. I called up Elecraft and tommorrow they will be sending a new one (or two) in the mail. Hopefully that will solve the problem as everything else voltage-wise checks out as it should. Thanks to all and I will update when I get the replacement part installed. 73,
James KB2FCV ----- Original Message ----- From: Jack Brindle <[EMAIL PROTECTED]> Date: Wednesday, August 17, 2005 12:38 pm Subject: Re: [Elecraft] KIO2 not working > I agree with Don's analysis. Everything looks good around the > MAX1406 > transceiver. Since you have -9 volts or so at the output (pin 5), > and > zero on the pin it feeds, there must be something amiss in between. > > The small inductors are easy to break - this might be the problem, > as > could be missing or 'bad' solder joints on either side of the > inductor or at J1 pin 2 itself. Use a VOM or ZDVM to make sure that > > L2 has continuity (might as well check L3 and L4 at the same time), > > then recheck the solder joints. If the inductor is bad, I'm sure > Scott will be happy to get you going with a good one... > > Good luck! > > - Jack Brindle, W6FB > -------------------------------------------------------------------- > ---- > --------------------- > > > _______________________________________________ Elecraft mailing list Post to: Elecraft@mailman.qth.net You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com