Hello,
My configuration : KX3, KXPA100 (with KXAT100, not used in normal
operation), coax line, SG230 (Smartuner), doublet.
My question :
In way to tune the Smarttuner, I must send some RF into the Smartuner
via the coax line. Before the tuning process begins, the SWR in the coax
line to the Smartuner may be very high. In this case, the KXPA100 goes
into Fault Condition ("Err Ant") ; no RF more, the tuning process stops.
Roundabouts :
1. PA off (via menu), tuning with KX3 barefoot.
2. KXAT100 on, KXAT100 tuning, Smartuner tuning, KXAT100 off.
Doing so (1. or 2 above), I can get the Smartuner tuned, but it's a bit
cumbersome.
Any idea ?
73
Luc/F6HJO/HB9ABB
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft@mailman.qth.net
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to arch...@mail-archive.com