Hi Tom My KRC2 is in constant use in my shack with my K2. I have a homebuilt box that does antenna switching and switches the antenna matching networks as well. I use tuned feeders on all bands except 160, so each band has to be matched separately. The KRC2 controls it all very well.
I've not needed the utility to reprogram anything, so no info there. Good luck and 73 Bob N6WG The Little Station with Attitude -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] Behalf Of Tom Althoff Sent: Sunday, January 15, 2006 2:53 PM To: elecraft@mailman.qth.net Subject: [Elecraft] KRC2 users? I don't think I've seen any comments regarding the KRC2. Ever since my K2/100 booted my Orion out of the shack I have been using my Array Solutions "Rat Pak" auto-antenna-switch in manual mode. The KRC2 would put me back in auto-antenna mode again. If I connect the KRC2 to my K2 I assume I can control the K2 from PC software transparantly from any software package that controls the K2 now. Correct? What would the disadvantage be if I wired the KRC2 for serial control (K2 and Kenwood) vs. Aux Bus mode (K2 only)? Has the KRC2 config utility been released yet? thanks! Tom K2TA _______________________________________________ Elecraft mailing list Post to: Elecraft@mailman.qth.net You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com _______________________________________________ Elecraft mailing list Post to: Elecraft@mailman.qth.net You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com