Sorry, I was thinking of the KX2 which always has the IF shift enabled.
In a KX3, the center of the IQ stream is approximately the dial setting.
I say approximately because some modes (AM, FM) or submodes (narrow SSB
using Weaver demodulation) there may be some offset regardless of the
setting of IF shift.
Thank you for your careful reading, Greg!
73,
Lyle KK7P
The signals at the IQ jack on the KX3 are analog, not digital. They
are centered approximately 8 kHz away from the dial frequency as the
KX3 uses an internal offset of 8 kHz. Depending on the firmware
release and user settable options, that offset may be on either side
of the center of the IQ audio.
Do you mean always 8 kHz off, or is this only if the IF shift is
enabled? I would expect a 0 offset without that.
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft@mailman.qth.net
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to arch...@mail-archive.com
