One question: On my K3S I cannot set the LO CUT to .35KHz it only
steps in .10 increments not 0.05 increments is there some CONFIG
item I need to change?
Temporarily switch to Shift/Width and set Shift to a value that,
when divided by two results in a value of X.X5. Now switch back
to Hi/Lo ... those value will end in X.X5 and step in increments
of X.10.
73,
... Joe, W4TV
On 2018-06-30 10:31 PM, Michael Gillen via Elecraft wrote:
Good info on the filters I had never tried the LO/HI CUT and I like it. One
question: On my K3S I cannot set the LO CUT to .35KHz it only steps in .10
increments not 0.05 increments is there some CONFIG item I need to change? I
looked through the CONFIG menus and Fred Cady’s book however I did not see
anything about setting that step.
73,
Michael
KK6RWK
On Jun 30, 2018, at 5:37 PM, Bill Frantz <fra...@pwpconsult.com> wrote:
Congratulations. The K3 is a really nice radio with extraordinary factory
support.
For SSB, I set low cut to .35 KHz and adjust the upper cut between 1.9 KHz and
2.8 KHz, depending on conditions. Higher makes for easier copy, but lower will
eliminate more noise, and help with nearby stations. Remember, the crystal
filters are to protect the AtoD converter in the receiver. The DSP has many
useful settings between those of the installed filters.
73 Bill AE6JV
On 6/30/18 at 5:07 PM, 1lasports...@cox.net (Bill) wrote:
I recently purchased a K3 and trying to set up for SSB.I do not do code.
Is there any recommended settings for the shift lo cut and width?
It has the KFL3A-400 and the KFL3A-12.8 8 pole filters installed
I have read the manual and it does not really help me.
Thanks
Bill
W3WGG
---------------------------------------------------------------------------
Bill Frantz | Re: Computer reliability, performance, and security:
408-356-8506 | The guy who *is* wearing a parachute is *not* the
www.pwpconsult.com | first to reach the ground. - Terence Kelly
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft@mailman.qth.net
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to mjgil...@yahoo.com
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft@mailman.qth.net
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to li...@subich.com
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft@mailman.qth.net
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to arch...@mail-archive.com
