On SSB a change of 50Hz bandwidth is usually insignificant.
Those who are blessed with perfect pitch may differ when listening to a
single tone, but for communications effectiveness, I just don't see the
point.
73,
Don W3FPR
On 7/1/2018 9:34 AM, ab2tc wrote:
Hi,
You don't have to do any math to do this. Just go to shift/width and change
the width one click (either direction.). Then switch back to HiCut/LoCut. To
reverse the process, do the same thing again.
AB2TC - Knut
Joe Subich, W4TV-4 wrote
One question: On my K3S I cannot set the LO CUT to .35KHz it only
steps in .10 increments not 0.05 increments is there some CONFIG
item I need to change?
Temporarily switch to Shift/Width and set Shift to a value that,
when divided by two results in a value of X.X5. Now switch back
to Hi/Lo ... those value will end in X.X5 and step in increments
of X.10.
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft@mailman.qth.net
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to arch...@mail-archive.com
