> The SWL "band" could be placed between 6 meters and > 160 meters in the BAND switch's rotation, and would > always contain the last non-amateur frequency used.
Let it fall in frequency sequence. If one used it for MW broadcast (US AM band) it would fall between 6 and 160 but if it was being used for WWV at 10 MHz it would fall between 40 and 30 Meters. This is the way both Icom and Yaesu do it. > The existing CONFIG:BND MAP menu item could be used to > enable/disable this feature: SWL IN would enable the new > feature, SWL OUT would restore the existing modus operandi > for those who prefer it. Alternatively, SWL OUT could simply disable storage of a frequency outside of the specific amateur band. If one tuned to WWV on 10 MHz then used the band up/down to go to 20 Meters, the 30 Meter bad would be reset to 10.100 and similarly on the other bands. It should not be too difficult to reset to the bottom of the band since the K3 already knows the band edges to disable out of band transmit. 73, ... Joe, W4TV > -----Original Message----- > From: elecraft-boun...@mailman.qth.net > [mailto:elecraft-boun...@mailman.qth.net] On Behalf Of Richard Ferch > Sent: Monday, November 16, 2009 8:40 AM > To: elecraft@mailman.qth.net > Subject: Re: [Elecraft] K3 Firmware Req for SWL band and > Using Memories > > > W5OV wrote: > > > Would it be reasonable to have an alternative "SWL" > selection of bands > > available as a CONFIG option? > > > > It could be as simple as BANDS: HAM / SWL > > > > When in SWL mode, no transmit would be possible and the various SWL > > bands could be "band-upped" or "band-downed" to change from > one to the > > other. Maybe show SWL somewhere on the display to indicate > that one is > > in SWL mode. > > This is still quite complex. I'd go for something simpler, namely a > single SWL "band" that contains all of the frequencies > outside the ham > bands. The SWL "band" could be placed between 6 meters and > 160 meters in > the BAND switch's rotation, and would always contain the last > non-amateur frequency used. > > The existing CONFIG:BND MAP menu item could be used to enable/disable > this feature: SWL IN would enable the new feature, SWL OUT > would restore > the existing modus operandi for those who prefer it. > > 73, > Rich VE3KI > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html