Ok I've resolved my issues with old notes and have cloned LinuxCNC and
my only question is what branch to add this information to?
JT
On 4/1/2021 5:24 AM, andy pugh wrote:
We have had iocintrol_v2 available for a long time, but the
documentation does not dscribe the difference very well.
There is documentation, on the Wiki:
http://wiki.linuxcnc.org/cgi-bin/wiki.pl?ToolchangerProtocolProposal
Which I have just been prompted to look through by a forum post.
It does seem to be better. I am thinking that perhaps we should move the
docs from the Wiki into the docs, and that the setup wizards and sample
configs should be set up to use it.
Thoughts?
_______________________________________________
Emc-developers mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/emc-developers
