IMHO if you have old hardware you use old versions of EMC. I have a
lathe with EMC2 and Ubuntu 10.
JT
On 11/26/25 18:00, andy pugh wrote:
The LinuxCNC codebase currently compiles a number of ISA-bus card drivers.
LinuxCNC master is only supported on Bookworm+
We only build 64-bit versions of LinuxCNC at the moment. (but I think
that a 32-bit build is possible, has anyone tried?)
It seems vanishingly improbable that it is even possible to run
LinuxCNC Master on an ISA-bus system.
For this reason I propose deleting the Servo-to-go, Motenc,
PC104 is more nuanced. We have a driver for the Tiro PC104 board.
Could anyone potentially still be using that?
Motenc seems to be PCI, though. And Vital systems are still extant, it
seems. Email sent.
_______________________________________________
Emc-developers mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/emc-developers
