I used an EMC2 2.2.2 disk to install on my mill and used update to get it to 2.2.3 and the file edit works great. Using the same disk to update my shaper from an ancient EMC1 BDI then updating it to 2.2.4, file edit in the drop down is grayed out along with edit tool table both of which I use a lot. Is this something that I did wrong or maybe this is a backgrade because of a proble. In any case I do apprieciate all the good that has been done with EMC, thanks again. Ed.
------------------------------------------------------------------------- Check out the new SourceForge.net Marketplace. It's the best place to buy or sell services for just about anything Open Source. http://ad.doubleclick.net/clk;164216239;13503038;w?http://sf.net/marketplace _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
