On Fri, 2008-05-30 at 09:16 -0700, Jorge Barrera wrote: ... snip > ... we discovered a faulty pin connection on the motor connector. > > This wasn't all, the ground in the building was not that good either > and a UPS was used to power the PC and the IO boards, this took care > of the false limit switch trigger that we where seeing. ... snip > Jorge Barrera > MFG.com > some project details: > http://www.mfgx.com/blogs/opensource/2008/05/15/open-source-hardware-the-beginning
Thank you for posting your results. I kind of take the mains for granted. -- Kirk Wallace (California, USA http://www.wallacecompany.com/machine_shop/ Hardinge HNC/EMC CNC lathe, Bridgeport mill conversion, doing XY now, Zubal lathe conversion pending Craftsman AA 109 restoration Shizuoka ST-N/EMC CNC) ------------------------------------------------------------------------- This SF.net email is sponsored by: Microsoft Defy all challenges. Microsoft(R) Visual Studio 2008. http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/ _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
