On Thu, 2008-10-16 at 11:32 -0400, John Domville wrote: ... snip > Z-476 (way off, gave up poking different numbers in) > > Is there a recommended procedure / formula for this type of > calibration?
> John Domville > Elmira NY Check out the documentation page, section 1.3.9.3 here: http://www.linuxcnc.org/docview/html//config_ini_config.html#sub:%5BAXIS %5D-Section or linuxcnc.org/docview/html//config_ini_config.html The INPUT_SCALE number should not be adjusted by trial and error. It should follow the physical configuration of your machine and most likely will be a recognizable number (1000, 500, 250 or similar). The strange numbers you are using might indicate a different problem. Check your output scale (1 or -1). Kirk ------------------------------------------------------------------------- This SF.Net email is sponsored by the Moblin Your Move Developer's challenge Build the coolest Linux based applications with Moblin SDK & win great prizes Grand prize is a trip for two to an Open Source event anywhere in the world http://moblin-contest.org/redirect.php?banner_id=100&url=/ _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users