On 07/03/2017 09:55 PM, Jon Elson wrote:
Go easy on yourself! EMC was a fairly complicated piece of software
when we took it over from NIST. It has grown quite a bit in
complexity since then. Many deficiencies or limitations have been
corrected by very sharp programming since then (HAL, Joints-axis and
the new trajectory planner, for instance) but these have increased
complexity. I was only competent in a small area of the code back
then (mostly servo region) and work hard to just keep aware of what is
new.
As for looking dumb, I have totally given up! I KNOW that what I
don't know is out there for everybody to see, but I still get great
use out of LinuxCNC, and HATS OFF to the guys who really know it so well!
Jon
I know how you feel. I feel pretty clueless compared to guys like Andy,
John, Seb, Sam and a whole bunch of others. I try to absorb the
knowledge here like a sponge, but my mind is more like a sieve. ;-)
Mark
------------------------------------------------------------------------------
Check out the vibrant tech community on one of the world's most
engaging tech sites, Slashdot.org! http://sdm.link/slashdot
_______________________________________________
Emc-users mailing list
Emc-users@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/emc-users