On Fri, Jan 22, 2010 at 11:23:55AM +0100, Harald Schmalzbauer wrote: > But I had some questions about zfs raidz states. I think that isn't > a matter of atacam but if I removed one disk, zpool status still > showed me the ada3 device "online". > After reinserting (and proper detection/initialisazion with cam, > ada3 was present again) and zpool clean, it set the devicea as > UNAVAIL sinve I/O errors. > I coudn't get the device into the pool again, no matter what I tried. > Only rebooting the machine helped. Then I could clean and scrub. > > What are the needed steps to provide a reinsterted hard disk to > geom? With the latest patches I don't need to issue any reset/rescan > comman, right? > So it's a zfs problem, right? My mistake in understanding?
I can't speak with regards to the new ATA-via-CAM stuff, but with the classic AHCI (meaning ataahci(4)), the procedure I've used reliably for quite some time on Intel ICHx controllers is this: For SATA disks that are purely UFS/UFS2: - Single-user mode might be required here; it varies - Terminate any processes which rely on filesystems on that disk - umount /filesystem - atacontrol detach ataX (where X = channel associated with disk) - Physically remove bad disk - Physically insert new disk - Wait 15 seconds for stuff to settle - atacontrol attach ataX (where X = previous channel detached) - sade / sysinstall / gpart / whatever you like - Restore data... :-) For SATA disks part of a ZFS mirror or raidz[123] pool: - zpool offline <pool> <disk> - atacontrol detach ataX (where X = channel associated with disk) - Physically remove bad disk - Physically insert new disk - Wait 15 seconds for stuff to settle - atacontrol attach ataX (where X = previous channel detached) - zpool replace <pool> <disk> - zpool online <pool> <disk> -- | Jeremy Chadwick j...@parodius.com | | Parodius Networking http://www.parodius.com/ | | UNIX Systems Administrator Mountain View, CA, USA | | Making life hard for others since 1977. PGP: 4BD6C0CB | _______________________________________________ freebsd-stable@freebsd.org mailing list http://lists.freebsd.org/mailman/listinfo/freebsd-stable To unsubscribe, send any mail to "freebsd-stable-unsubscr...@freebsd.org"