I think you may be having interrupt conflict.
Try to boot into Windows and See I you could see all the devices you have
installed? Try to boot linux at init level 1 ie. at LILO: linux 1 rw
you will see #bash. Now from this prompt you could configure the devices.
Dhiraj
On 20 May 2000, MYKE OLSON wrote:
> I am having a problem with my linux box and I am lost as to how to fix
> it...when I try to run "ifconfig" (or when it runs at startup), i get the
> following message:
> ifconfig: can't resolve symbol '_h_errno'
> Segmentation fault
>
> And I can't figure out why. :(
> Sequence of events that might have led up to this:
> 1. Shut down machine.
> 2. Installed PS/2 port and 2 serial ports (they're onboard, I just hadn't
> connected them yet).
> 3. Rebooted into Winblows.
> 4. Tried to mess around with re-installing a DVD drive. Gave up.
> 5. Rebooted into Linux (Slakware 2.0.35).
> 6. Got the message that ifconfig had a problem and the network
> interface (eth0) wasn't working.
> 7. Cursed and Rebooted. Same problem.
> 8. Removed serial ports and PS/2 port cables.
> 9. Rebooted. Same thing.
> 10. Disabled serial ports in the BIOS. Rebooted. Same thing.
> 11. Tried disabling everything in rc.inet1 and do it manually after the
> machine is booted. Same problem.
>
> Does anyone have any suggestions? Why would this happen all of
> a sudden just because I installed a couple cables and rebooted into
> Windows? Any help would be greatly appreciated!
>
> Myke Olson
>
>
> *** myke eric scott olson ***
> E-mail: [EMAIL PROTECTED]
> Webpage: http://green.eaw.net/~myke/
>
> ____________________________________________________________________
> Get free email and a permanent address at http://www.netaddress.com/?N=1
>
