Hello.

Bartlomiej Zolnierkiewicz wrote:

* Convert cmd64x, hpt366 and pdc202xx_old host drivers to use
 pci_resource_start(hwif->pci_dev, 4) instead of hwif->dma_master.

Before using pci_resource_start(), the code should check pci_resource_len() to ensure it is the appropriate size.

It would be very wise to ensure that pci_resource_flags()&IORESOURCE_IO is true, too.

Sure but since the old code hasn't been doing these checks (old code
just did pci_resource_start() -> hwif->dma_base -> hwif->dma_master)
this is a separate issue from what the patch tries to achieve.

Nonetheless this is duplicating an existing bug $N times... not ideal :)

The existing bug is that the methods converted to use pci_resource_start()
may be set in hwif instance and used even if the BAR4 is invalid.  Therefore
the above patch is correct and it isn't duplicating the existing bug. :)

However I agree that all these pci_resource_start()s could be a bit confusing
so here is 'take 2'.

Yeah, they are. Actually, I was thinking about such patch ~1.5 years ago *but* using a different approach -- namely, hwif->extra_base.

[PATCH] ide: remove ->dma_master field from ide_hwif_t (take 2)

* Convert cmd64x, hpt366 and pdc202xx_old host drivers to use
  pci_resource_start(hwif->pci_dev, 4) instead of hwif->dma_master.

* Remove no longer needed ->dma_master field from ide_hwif_t.

v2:
* Use the more readable 'hwif->dma_base - (hwif->channel * 8)' instead of
  pci_resource_start(hwif->pci_dev, 4).

   s/readable/clumsy/? ;-)

Signed-off-by: Bartlomiej Zolnierkiewicz <[EMAIL PROTECTED]>

Index: b/drivers/ide/ide-dma.c
===================================================================
--- a/drivers/ide/ide-dma.c
+++ b/drivers/ide/ide-dma.c
@@ -1006,11 +1006,6 @@ void ide_setup_dma(ide_hwif_t *hwif, uns
hwif->dma_base = base; - if (hwif->mate)
-               hwif->dma_master = hwif->channel ? hwif->mate->dma_base : base;
-       else
-               hwif->dma_master = base;
-
        if (!(hwif->dma_command))
                hwif->dma_command    = hwif->dma_base;
        if (!(hwif->dma_vendor1))

  Ugh, these extra parens... :-)

[...]
Index: b/drivers/ide/pci/cmd64x.c
===================================================================
--- a/drivers/ide/pci/cmd64x.c
+++ b/drivers/ide/pci/cmd64x.c
@@ -333,13 +333,14 @@ static void cmd64x_set_dma_mode(ide_driv
 static int cmd648_ide_dma_end (ide_drive_t *drive)
 {
        ide_hwif_t *hwif        = HWIF(drive);
+       unsigned long addr      = hwif->dma_base - (hwif->channel * 8) + 0x01;

Dunno... pci_resource_start() looked better to my taste. Except I'd probably called the variable 'base' and wouldn't + 0x01 right away.

        int err                 = __ide_dma_end(drive);
        u8  irq_mask            = hwif->channel ? MRDMODE_INTR_CH1 :
                                                  MRDMODE_INTR_CH0;
-       u8  mrdmode             = inb(hwif->dma_master + 0x01);
+       u8  mrdmode             = inb(addr);
/* clear the interrupt bit */
-       outb(mrdmode | irq_mask, hwif->dma_master + 0x01);
+       outb(mrdmode | irq_mask, addr);
return err;
 }
@@ -364,10 +365,11 @@ static int cmd64x_ide_dma_end (ide_drive
 static int cmd648_ide_dma_test_irq (ide_drive_t *drive)
 {
        ide_hwif_t *hwif        = HWIF(drive);
+       unsigned long addr      = hwif->dma_base - (hwif->channel * 8) + 0x01;

   Same comment here...

        u8 irq_mask             = hwif->channel ? MRDMODE_INTR_CH1 :
                                                  MRDMODE_INTR_CH0;
        u8 dma_stat             = inb(hwif->dma_status);
-       u8 mrdmode              = inb(hwif->dma_master + 0x01);
+       u8 mrdmode              = inb(addr);
#ifdef DEBUG
        printk("%s: dma_stat: 0x%02x mrdmode: 0x%02x irq_mask: 0x%02x\n",
Index: b/drivers/ide/pci/hpt366.c
===================================================================
--- a/drivers/ide/pci/hpt366.c
+++ b/drivers/ide/pci/hpt366.c
@@ -845,32 +845,33 @@ static int hpt374_ide_dma_end(ide_drive_

   This just asks to be:

 static void hpt3xxn_set_clock(ide_hwif_t *hwif, u8 mode)
 {
        unsigned long base = hwif->extra_base;
        u8 scr2 = inb(base + 0x5b);

        if ((scr2 & 0x7f) == mode)
                return;

        /* Tristate the bus */
        outb(0x80, base + 0x53);
        outb(0x80, base + 0x57);

        /* Switch clock and reset channels */
        outb(mode, base + 0x5b);
        outb(0xc0, base + 0x59);

        /*
         * Reset the state machines.
         * NOTE: avoid accidentally enabling the disabled channels.
         */
        outb(inb(base + 0x50) | 0x32, base + 0x50);
        outb(inb(base + 0x54) | 0x32, base + 0x54);

        /* Complete reset */
        outb(0x00, base + 0x59);

        /* Reconnect channels to bus */
        outb(0x00, base + 0x53);
        outb(0x00, base + 0x57);
}

Index: b/drivers/ide/pci/pdc202xx_old.c
===================================================================
--- a/drivers/ide/pci/pdc202xx_old.c
+++ b/drivers/ide/pci/pdc202xx_old.c
@@ -162,7 +162,7 @@ static u8 pdc202xx_old_cable_detect (ide

   And this asks to be:

  */
 static void pdc_old_enable_66MHz_clock(ide_hwif_t *hwif)
 {
-       unsigned long clock_reg = hwif->dma_master + 0x11;
+       unsigned long clock_reg = hwif->extra_base + 0x01;

        u8 clock = inb(clock_reg);
outb(clock | (hwif->channel ? 0x08 : 0x02), clock_reg);
@@ -170,7 +170,7 @@ static void pdc_old_enable_66MHz_clock(i
static void pdc_old_disable_66MHz_clock(ide_hwif_t *hwif)
 {
-       unsigned long clock_reg = hwif->dma_master + 0x11;

+       unsigned long clock_reg = hwif->extra_base + 0x01;

        u8 clock = inb(clock_reg);
outb(clock & ~(hwif->channel ? 0x08 : 0x02), clock_reg);
@@ -193,7 +193,7 @@ static void pdc202xx_old_ide_dma_start(i
        if (drive->media != ide_disk || drive->addressing == 1) {
                struct request *rq      = HWGROUP(drive)->rq;
                ide_hwif_t *hwif        = HWIF(drive);
-               unsigned long high_16   = hwif->dma_master;

+               unsigned long high_16   = hwif->extra_base;

                unsigned long atapi_reg = high_16 + (hwif->channel ? 0x24 : 
0x20);
                u32 word_count  = 0;
                u8 clock = inb(high_16 + 0x11);
@@ -212,7 +212,7 @@ static int pdc202xx_old_ide_dma_end(ide_
 {
        if (drive->media != ide_disk || drive->addressing == 1) {
                ide_hwif_t *hwif        = HWIF(drive);
-               unsigned long high_16   = hwif->dma_master;

+               unsigned long high_16   = hwif->extra_base;

                unsigned long atapi_reg = high_16 + (hwif->channel ? 0x24 : 
0x20);
                u8 clock                = 0;
@@ -228,7 +228,7 @@ static int pdc202xx_old_ide_dma_end(ide_
 static int pdc202xx_old_ide_dma_test_irq(ide_drive_t *drive)
 {
        ide_hwif_t *hwif        = HWIF(drive);
-       unsigned long high_16   = hwif->dma_master;

+       unsigned long high_16   = hwif->extra_base;

        u8 dma_stat             = inb(hwif->dma_status);
        u8 sc1d                 = inb(high_16 + 0x001d);
@@ -271,7 +271,7 @@ static void pdc202xx_dma_timeout(ide_dri static void pdc202xx_reset_host (ide_hwif_t *hwif)
 {
-       unsigned long high_16   = hwif->dma_master;
+       unsigned long high_16   = hwif->dma_base - (hwif->channel * 8);

        unsigned long high_16   = hwif->extra_base;

        u8 udma_speed_flag      = inb(high_16 | 0x001f);

MBR, Sergei
-
To unsubscribe from this list: send the line "unsubscribe linux-ide" in
the body of a message to [EMAIL PROTECTED]
More majordomo info at  http://vger.kernel.org/majordomo-info.html

Reply via email to