Hello.

Bartlomiej Zolnierkiewicz wrote:

Index: b/drivers/ide/pci/hpt366.c
===================================================================
--- a/drivers/ide/pci/hpt366.c
+++ b/drivers/ide/pci/hpt366.c
@@ -845,32 +845,33 @@ static int hpt374_ide_dma_end(ide_drive_

  This just asks to be:

   No, it doesn't cause that way one would only break it.

static void hpt3xxn_set_clock(ide_hwif_t *hwif, u8 mode)
{

   unsigned long base = hwif->extra_base;

   Sorry for a thinko. All offsets below shoud be really 0x6x, not 0x5x...

Here we go again... :)

[PATCH] ide: remove ->dma_master field from ide_hwif_t (take 4)

* Convert cmd64x, hpt366 and pdc202xx_old host drivers to use
  pci_resource_start(hwif->pci_dev, 4) instead of hwif->dma_master.

* Remove no longer needed ->dma_master field from ide_hwif_t.

v2:
* Use the more readable 'hwif->dma_base - (hwif->channel * 8)' instead of
  pci_resource_start(hwif->pci_dev, 4).

v3:
* Use hwif->extra_base in hpt366/pdc20xx_old + some cosmetic fixups over v2
  (suggested by Sergei).

   Huh? I don't see where you're using extra_base in hpt366.c

v4:
* Correct offsets in hpt3xxn_set_clock().

Signed-off-by: Bartlomiej Zolnierkiewicz <[EMAIL PROTECTED]>

   Unfortunately, I have to NAK the patch... :-/

Index: b/drivers/ide/pci/hpt366.c
===================================================================
--- a/drivers/ide/pci/hpt366.c
+++ b/drivers/ide/pci/hpt366.c
@@ -845,32 +845,33 @@ static int hpt374_ide_dma_end(ide_drive_
static void hpt3xxn_set_clock(ide_hwif_t *hwif, u8 mode)
 {
-       u8 scr2 = inb(hwif->dma_master + 0x7b);
+       unsigned long base = hwif->dma_base - (hwif->channel * 8);

Should be hwif->extra_base - 0x10 or else the following code will touch all the wrong/reserved registers; one also can use hwif->extra_base ISO 'base' and change all the offsets to 0x6x...

+       u8 scr2 = inb(base + 0x6b);
if ((scr2 & 0x7f) == mode)
                return;
/* Tristate the bus */
-       outb(0x80, hwif->dma_master + 0x73);
-       outb(0x80, hwif->dma_master + 0x77);
+       outb(0x80, base + 0x63);
+       outb(0x80, base + 0x67);

        /* Switch clock and reset channels */
-       outb(mode, hwif->dma_master + 0x7b);
-       outb(0xc0, hwif->dma_master + 0x79);
+       outb(mode, base + 0x6b);
+       outb(0xc0, base + 0x69);
/*
         * Reset the state machines.
         * NOTE: avoid accidentally enabling the disabled channels.
         */
-       outb(inb(hwif->dma_master + 0x70) | 0x32, hwif->dma_master + 0x70);
-       outb(inb(hwif->dma_master + 0x74) | 0x32, hwif->dma_master + 0x74);
+       outb(inb(base + 0x60) | 0x32, base + 0x60);
+       outb(inb(base + 0x64) | 0x32, base + 0x64);
/* Complete reset */
-       outb(0x00, hwif->dma_master + 0x79);
+       outb(0x00, base + 0x69);
/* Reconnect channels to bus */
-       outb(0x00, hwif->dma_master + 0x73);
-       outb(0x00, hwif->dma_master + 0x77);
+       outb(0x00, base + 0x63);
+       outb(0x00, base + 0x67);
 }

Huh? That's wrong -- if you're setting base to the value of the former value of hwof->dma_master, the register offsets shouldn't change!

Index: b/drivers/ide/pci/pdc202xx_old.c
===================================================================
--- a/drivers/ide/pci/pdc202xx_old.c
+++ b/drivers/ide/pci/pdc202xx_old.c
@@ -193,7 +193,7 @@ static void pdc202xx_old_ide_dma_start(i
        if (drive->media != ide_disk || drive->addressing == 1) {
                struct request *rq      = HWGROUP(drive)->rq;
                ide_hwif_t *hwif        = HWIF(drive);
-               unsigned long high_16   = hwif->dma_master;
+               unsigned long high_16   = hwif->extra_base - 16;
                unsigned long atapi_reg = high_16 + (hwif->channel ? 0x24 : 
0x20);

That 'high_16' is *not* a good name in this case -- it would've been if we didn't subtract 16. So, I'd wrote:

                unsigned long atapi_reg = hwif->extra_base +
                                         (hwif->channel ? 0x14 : 0x10);

@@ -212,7 +212,7 @@ static int pdc202xx_old_ide_dma_end(ide_
 {
        if (drive->media != ide_disk || drive->addressing == 1) {
                ide_hwif_t *hwif        = HWIF(drive);
-               unsigned long high_16   = hwif->dma_master;
+               unsigned long high_16   = hwif->extra_base - 16;
                unsigned long atapi_reg = high_16 + (hwif->channel ? 0x24 : 
0x20);
                u8 clock                = 0;

   Same here...

@@ -228,7 +228,7 @@ static int pdc202xx_old_ide_dma_end(ide_
 static int pdc202xx_old_ide_dma_test_irq(ide_drive_t *drive)
 {
        ide_hwif_t *hwif        = HWIF(drive);
-       unsigned long high_16   = hwif->dma_master;
+       unsigned long high_16   = hwif->extra_base - 16;
        u8 dma_stat             = inb(hwif->dma_status);
        u8 sc1d                 = inb(high_16 + 0x001d);

   ... and here...

@@ -271,7 +271,7 @@ static void pdc202xx_dma_timeout(ide_dri
static void pdc202xx_reset_host (ide_hwif_t *hwif)
 {
-       unsigned long high_16   = hwif->dma_master;
+       unsigned long high_16   = hwif->extra_base - 16;
        u8 udma_speed_flag      = inb(high_16 | 0x001f);

   ... and here too.

        outb(udma_speed_flag | 0x10, high_16 | 0x001f);

MBR, Sergei
-
To unsubscribe from this list: send the line "unsubscribe linux-ide" in
the body of a message to [EMAIL PROTECTED]
More majordomo info at  http://vger.kernel.org/majordomo-info.html

Reply via email to