Hi Josh,
Thank you for the patch.
On Thursday 09 April 2015 17:01:46 Josh Wu wrote:
> To program ISI control register, the pixel clock should be enabled.
That's an awful hardware design :-(
> So without pixel clock (from sensor) enabled, disable ISI controller is
> not make sense. So this patch remove those code.
>
> Signed-off-by: Josh Wu <josh...@atmel.com>
> ---
>
> Changes in v2:
> - this file is new added.
>
> drivers/media/platform/soc_camera/atmel-isi.c | 5 -----
> 1 file changed, 5 deletions(-)
>
> diff --git a/drivers/media/platform/soc_camera/atmel-isi.c
> b/drivers/media/platform/soc_camera/atmel-isi.c index c125b1d..31254b4
> 100644
> --- a/drivers/media/platform/soc_camera/atmel-isi.c
> +++ b/drivers/media/platform/soc_camera/atmel-isi.c
> @@ -131,8 +131,6 @@ static int configure_geometry(struct atmel_isi *isi, u32
> width, return -EINVAL;
> }
>
> - isi_writel(isi, ISI_CTRL, ISI_CTRL_DIS);
> -
> cfg2 = isi_readl(isi, ISI_CFG2);
Can the configuration registers be accessed when the pixel clock is disabled ?
> /* Set YCC swap mode */
> cfg2 &= ~ISI_CFG2_YCC_SWAP_MODE_MASK;
> @@ -843,7 +841,6 @@ static int isi_camera_set_bus_param(struct
> soc_camera_device *icd)
>
> cfg1 |= ISI_CFG1_THMASK_BEATS_16;
>
> - isi_writel(isi, ISI_CTRL, ISI_CTRL_DIS);
> isi_writel(isi, ISI_CFG1, cfg1);
>
> return 0;
> @@ -1022,8 +1019,6 @@ static int atmel_isi_probe(struct platform_device
> *pdev) if (isi->pdata.data_width_flags & ISI_DATAWIDTH_10)
> isi->width_flags |= 1 << 9;
>
> - isi_writel(isi, ISI_CTRL, ISI_CTRL_DIS);
> -
> irq = platform_get_irq(pdev, 0);
> if (IS_ERR_VALUE(irq)) {
> ret = irq;
--
Regards,
Laurent Pinchart
--
To unsubscribe from this list: send the line "unsubscribe linux-media" in
the body of a message to majord...@vger.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
