Am 21.02.2018 um 16:04 schrieb Jürgen Spitzmüller:
Am Mittwoch, den 21.02.2018, 15:56 +0100 schrieb Wolfgang Engelmann:
I could send a presentation with those curled arrows (tomorrow, if
wanted). They can not be cut and pasted, otherwise one might be
able
to find out the coding and use a replacement.
Note that in many cases, the separator insertion is intended to
maintain the output of old documents.
I have attached a lyx file which shows (only) the bend arrow. If
looked
at the file with an editor it shows for the body part:
\begin_body
\begin_layout Standard
\begin_inset Separator latexpar
\end_inset
\end_layout
\begin_layout Standard
\end_layout
\end_body
\end_document
The bend arrow in the lyx display corresponds to
\begin_inset Separator latexpar
as found out by the gurus.
My question is, whether it is safe for a large document (e.g. books)
to
open the lyx file with an editor, remove begin_inset Separator, save
it
and run lyx again, hopefully successfully. However, the latexpar
should
also be removed, and this can also be something else (the bend
arrows
occur also in a legend, at the end of chapters, sections etc). So it
should be removed in some more eleborate way (SED??). Or is there a
better way?
It would save a lot of time instead of removing those separator
beasts
by hand, if I need older lyx files for the newer lyx versions.
The following command sequence (to be inserted in the minibuffer)
removes all latexpar separators in the document and transforms the par
separator to normal separators:
command-sequence inset-forall Separator:parbreak inset-modify separator
plain ; inset-forall Separator:latexpar char-delete-forward
very good! Thanks a lot, Jürgen! The minibuffer goes where?
Wolfgang
HTH
Jürgen
Wolfgang
