Hi Kevin and all Looks like I found the problems. 1. missing Jumper JU 955 Squelch Pot to Audio/Squelch Board 2. Broken wire on both the Squelch Pot low and Vol Hi. 3. Bad connection Pin 9 that connects to the audio/Squelch Board Took the easy way out and ran a new wire. Thanks for the support and forcing me to turn the unit upside down and backwards etc. Pulling the Receiver interconnect board is a pain but worth it.
Where do you pull the disc off for an external Squelch controller and control system I have been using pin 15 of the RX connector on the main board. Ralph ----- Original Message ----- From: "Kevin Custer" <kug...@kuggie.com> To: Repeater-Builder@yahoogroups.com Sent: Monday, February 16, 2009 6:05:27 AM GMT -07:00 U.S. Mountain Time (Arizona) Subject: Re: [Repeater-Builder] Micor Repeater Ralph, Okay, I mis-understood. I thought the repeater that you are working on was at your son's place. Let me know when you want to get started and I'll try to walk you through. Oh - one question, is it a Unified or Non Unified Chassis? Kevin Hi Kevin This repeater I am working on is here in Tucson. I will have additional data tomorrow. I will email it to you. I need to make some more tests to understand what I am missing. Thanks Ralph