Dr S N Henson wrote:
>
> I suspect the answer is 'none of the above' :-)
Yes and no :-) (see below).
>
> I'm compiling MUSCLE 0.9.1 and the GemPC430 driver from source. There
> are a few problems with 'make install' in MUSCLE, at least on my setup:
> for example it installs reader.conf in /usr/local/etc but expects to
> find it in /etc and it doesn't seem to install the pcsd binary (well
> script) anywhere.
The default 'make install' does not compile pcscd with usb support
(which was the reason of the "problem" with the packages). You should
first './configure --enable-usb' to enable usb support. If you have the
GemPC430 bundle in the 'drivers' folder of the pcsc install, it should
work.
> BTW do you know anything about the GPR400 device driver? One problem I
> get with that is that after the 'power down' command it stays powered
> down and doesn't respond to any commands (including 'reset' which I
> believe is supposed to power it up again). A reboot or eject/reinsert is
> needed.
I don't know anything about it. I'll see if I can find out anything
regarding this issue.
Cheers,
JLuc.
***************************************************************
Linux Smart Card Developers - M.U.S.C.L.E.
(Movement for the Use of Smart Cards in a Linux Environment)
http://www.linuxnet.com/smartcard/index.html
***************************************************************
