I didn't bother about paying/asking for matched default filters for my KRX3.
The one in the main board has a -0.93kHz offset and the one in the KRX3 is
-0.83kHz.
Shifting them both to -0.88kHz seems to make no difference to performance -
would you expect a 50Hz shift in a nominal -6dB b/w of
Stewart,
You are correct that the importance of the offset is inversely
proportional to the filter width. A 50 Hz shift not make much
difference with the 2.7 or 2.8 kHz width, but it certainly will make a
big difference at a 200 Hz width.
73,
Don W3FPR
GW0ETF wrote:
I didn't bother about
I received the KRX3 and the DVR today and am about to upgrade my k3. I am
using the 2.7 if roofing filter in the main unit and requested and paid for
a matching filter for the sub receiver.
The main receiver offset is -.97 but the new 2.k filter is marked -.93.
My question is are these a match
what kind of
plugs I need to buy for replacement.
Willis 'Cookie' Cooke
K5EWJ
--- On Sat, 12/20/08, aa1o aa1o.ra...@comcast.net wrote:
From: aa1o aa1o.ra...@comcast.net
Subject: [Elecraft] k3 matching filters
To: elecraft@mailman.qth.net
Date: Saturday, December 20, 2008, 2:30 PM
I received
...My DVR seems to work, but I have not been able to find
any instructions for operating.
From the latest beta firmware release notes [with slight editorial from
me ]:
Support for Digital Voice Recorder option (KDVR3):
Note: The following information is more accurate than the DVR
, December 20, 2008 6:52 PM
Subject: Re: [Elecraft] k3 matching filters
Hi,
The main receiver offset is -.97 but the new 2.k filter is marked -.93.
My question is are these a match or did I get the wrong part?
Doesn't sound like it. I'd double check with Elecraft if I were you.
vy 73 de toby
The main receiver offset is -.97 but the new 2.k filter is marked -.93.
My question is are these a match or did I get the wrong part?
I think you may have received the wrong filter. At this point, I'd
install the new filter in the KRX3, but set the Main and KRX3 offsets to
-0.95 (split the
] k3 matching filters
The main receiver offset is -.97 but the new 2.k filter is marked -.93.
My question is are these a match or did I get the wrong part?
I think you may have received the wrong filter. At this point, I'd
install the new filter in the KRX3, but set the Main and KRX3 offsets
, set them both to -0.95. This
results in a worse case center offset of 20 Hz, which is not detectable. :-)
73,
Eric
_..._
-Original Message-
From: aa1o aa1o.ra...@comcast.net
Date: Saturday, Dec 20, 2008 2:30 pm
Subject: [Elecraft] k3 matching filters
To: elecraft@mailman.qth.net
I
The main receiver offset is -.97 but the new 2.k filter is marked -.93.
My question is are these a match or did I get the wrong part?
I think you may have received the wrong filter.
Shows what I know. The matching spec is to within 40 Hz, so you in fact
received the correct filter.
Which
10 matches
Mail list logo