Hello everyone, I'm trying to rig up a vent door in a kit-car so I can open
and close the vent remotely. Its would be tough to run a stiff cable to the door
due to its location, so I was thinking of using a heavy duty landing gear servo
located at the door, and a simple on/off switch under the dash to activate
the servo. My question is what I would need to do to run the servo off the 12
volt car system? My electronics knowledge is limited but I'm do
ok with a soldering iron! Thanks in advance for any
suggestions.
Stan Sadorf
|
- [RCSE] Servo on 12V question, slightly OT Soareyes
- Re: [RCSE] Servo on 12V question, slightly OT Doug McLaren