Dear All
Is there an ROI setting in the " *NC393-F-CS* " product? And does changing
*R*egion *O*f *I*nterest increase the frame rate?
Thank you for your help
Ali
On Sun, Mar 8, 2020 at 12:22 PM Elphel Support <
support-list@support.elphel.com> wrote:
> Hello Ali,
>
> On Semiconductor purchased most of the other US sensor manufacturers. That
> particular MT9M001 you mention (as well as MT9P006 we use in most
> applications) was first produced by Micron ("MT" means "Micron
> Technology"), then it was Aptina, and finally On Semiconductor. They even
> own Kodak CCDs now - completely different technology.
>
> Support of a new sensor requires 3 parts:
> 1) Physical PCB for the sensor - most sensors have different pinouts and
> interface requirements
> 2) FPGA design that supports the interface
> 3) Kernel driver to support the sensor operation.
>
> As all the 3 listed parts are free software/open hardware at Elphel, it is
> possible to perform development w/out us and there is an example when
> engineers from Lithuania interfaced high-speed CMOSIS sensor themselves. So
> it is doable, though not very simple. We will definitely provide help and
> answer questions that we are able to, but the development itself is yours.
>
> We do not have ready to use solution for the VITA200.
>
> Andrey
>
>
>
> ---- On Sat, 07 Mar 2020 08:25:42 -0800 *ali tamimi
> <tamimial...@gmail.com <tamimial...@gmail.com>>* wrote ----
>
>
>
> ---------- Forwarded message ---------
> From: *ali tamimi* <tamimial...@gmail.com>
> Date: Sat, Feb 29, 2020 at 12:08 AM
> Subject: driving any desired sensor
> To: <mail...@support.elphel.com>
>
>
> Satureday, 29 February 2020
>
> Dear All
>
> I recently read about your products. I want to know:
>
> 1. Does 10393 support VITA200-
> https://www.onsemi.com/products/sensors/image-sensors-processors/image-sensors/vita2000,
> and MT9M001-
> https://www.onsemi.com/products/sensors/image-sensors-processors/image-sensors/mt9m001,
> sensors manufactured by ON Semiconductor company?
>
> 2. Are the support sensors limited to the few sensors introduced on your
> sales site or can any desired sensor be drive with 10393?
>
> 3. If the answer to question 2 is yes, what are the requirements for
> driving any desired sensor? (I guess e. g. PCB design for sensor packaging
> and Verilog code modification, etc.)
>
> Thank you for your help
>
> Ali
> _______________________________________________
> Support-list mailing list
> Support-list@support.elphel.com
> http://support.elphel.com/mailman/listinfo/support-list_support.elphel.com
>
>
>
>
_______________________________________________
Support-list mailing list
Support-list@support.elphel.com
http://support.elphel.com/mailman/listinfo/support-list_support.elphel.com
