I used it long time ago. Cannot recall how exactly I did that. But you need some sort of REGEX combination to route SMS to certain SMSCs, and then putting allowed/denied parameters in place as well.
On Tue, Nov 12, 2013 at 11:01 PM, Porter, Kelvin <kelvin.por...@h3net.com>wrote: > Hi, > > > > I did some looking and it appears that I might be able to accomplish what > I want using allowed- and/or denied-prefix. The description is a bit > ambiguous though, these variables determines whether a SMS message can be > “sent through”. The routing is unclear as to whether the prefix filtering > is being applied to the sender or the receiver. I could look at the code, > but does anyone know off-hand which number is being filtered? > > > > Thank you for the pointer. > > > > Regards, > > > > Kelvin R. Porter > > > > *From:* ha...@aeon.pk [mailto:ha...@aeon.pk] > *Sent:* Tuesday, November 12, 2013 11:27 AM > > *To:* Porter, Kelvin > *Cc:* users@kannel.org > *Subject:* Re: SMSC-ID routing based on to/from on SMSBox? > > > > Have you tried allowed-smsc-id and denied-smsc-id parameters in group=smsc? > > > > On Tue, Nov 12, 2013 at 10:10 PM, Porter, Kelvin <kelvin.por...@h3net.com> > wrote: > > Hi, > > > > The scenario is the following… > > > > I have customers that are sending HTTP requests to the SMSBox instance to > initiate the sending of MT messages. Depending on the intended destination > of those messages (i.e., the to/receiver number), I need to direct the > message to one set of SMSC links or the other in the BearerBox. The > application performing the HTTP requests does not have any way of > determining the set of numbers that need to go to a particular SMSC. So, I > am looking for a way to configure the SMSBox so that the SMSC is specified > for certain MT destinations. > > > > In the opensmppbox, I would use the smsc-route option to set which SMSC > was specified before it was sent to the bearerbox. I am looking for > equivalent functionality. Have I overlooked something or is the > functionality, not there? > > > > Thank you. > > > Regards, > > > > Kelvin R. Porter > > > > *From:* ha...@aeon.pk [mailto:ha...@aeon.pk] > *Sent:* Tuesday, November 12, 2013 10:48 AM > *To:* Porter, Kelvin > *Cc:* users@kannel.org > *Subject:* Re: SMSC-ID routing based on to/from on SMSBox? > > > > Can you explain your scenario with an example please? Would be easier to > understand what you need. > > > > On Mon, Nov 11, 2013 at 11:56 PM, Porter, Kelvin <kelvin.por...@h3net.com> > wrote: > > Hi, > > > > I am writing to insure that I have not overlooked an option. In my > application, I have a need to specify SMSC based on where the message is > being sent to (the users will not specify the smsc in the HTTP request). > Basically, I need to insure some MT destinations are treated differently > that the others, independent of what is specified in the request. I have > looked at the source and it does not appear that this functionality is > implemented. Have I missed something? > > > > I am looking for something akin to the “smsc-route” option in the > opensmppbox. I may attempt to splice in this code from the opensmppbox, if > I must. Is there any interest in this functionality? > > > > Regards, > > > > Kelvin R. Porter > > > > > > > > >