Hi! I´ve been running XFree86 4.5.0 on my Linux system since it was first release without problems. I replaced an old Nec XE17 monitor with a Dell E771a this morning and I can no longer get X to start in [EMAIL PROTECTED] resolution. It will crank up to [EMAIL PROTECTED] (I believe) max.
I tried running "X -autoconfig" from the command line but I got an error about not being able to access a framebuffer mode. No biggie, so I ran xf86config and configured the settings for the new monitor that way. Attached are my current XF86Config and XFree86.0.log files. How can I get the resolution back up to [EMAIL PROTECTED] Here are the specs on the Dell monitor: http://support.dell.com/support/edocs/monitors/j51jk/en/specs.htm I did see some entries in XFree86.0.log file which indicated the monitor reported 1024x768 as the ¨preferred¨ resolution and that´s what XFree86 went with. Thanks in advance for your time and assistance! Peace... Tom _______________________________________________ XFree86 mailing list XFree86@XFree86.Org http://XFree86.Org/mailman/listinfo/xfree86