Hi Ralf, I have just installed Jconv and it seem to be working fine. However there seems to be some problem wiht my sound card. For some reason the microphone input or the line input doesn't seem to work. It works fine in Windows. I am new to this so I apologize if the question sounds a little stupid, but how do I use ecasound to connect to jack and play a sound file using this reverb? I tried something like the following: ecasound -i test.wav -o jack But it didn't work. Best regards and many thanks for all your help, Christian
On 2008-10-30 at 02:33 Ralf Mardorf wrote: >>>> Wow, I played a Mark III sound by my DX7, send the signal from one >>>> channel over my mixing console sub 1-2 to the main and get the output >>>> back in 2 other channels send to sub 3-4 and heard the mix by >monitoring >>>> main and sub 3-4. I had to do some settings by the sound card mixer and >>>> it was great. A very, very good reverb. First I was disappointed, >>>> because of a bad panorama, while the reverb was very good, but it was >my >>>> amp, balance is bad, I connected the headphones to my mixing console >and >>>> it was wow. The reverb also sounds good for the speakers. > > >I didn't tested it, I just listened to that example. I don't know what >will happen if this reverb is used for a complete song and what will >happen if the stereo mix is switched to mono and all that stuff. So >please don't stone me, if I'm wrong. Without comparing reverbs, it seems >to be better than geverb and all those Linux reverbs. _______________________________________________ 64studio-users mailing list [email protected] http://lists.64studio.com/mailman/listinfo/64studio-users
