Hi
I've got the following problem.
The following shows up in the activity log:
ANR8944E Hardware or media error on drive DRIVE1
(mt2.0.0.2) (OP=LOCATE, Error Number=23, CC=0, KEY=03,
ASC=14, ASCQ=00, SENSE=70.00.03.00.00.00.00.1C.00.00.00.-
00.14.00.07.00.20.84.FF.FF.00.03.20.20.20.20.20.20.20.0D-
.00.00.1C.A7.02.00.00.00.00.00.00.00.00.00.00.00.00.00.0-
0.00.00.00.00.00.00.00.00.00.00.00.00.00.00.00.00.00.00.-
00.00.00.00.00.00.00.00.00.00.00.00.00.00.00.00.00.00.00-
.00.00.00.00.00.00.00.00.00.00, Description=An
undetermined error has occurred). Refer to Appendix D in
the 'Messages' manual for recommended action.
11-06-2003 07:59:14 ANR8359E Media fault detected on LTO volume 000765L1 in
drive DRIVE1 (mt2.0.0.2) of library 3583LIB.
11-06-2003 08:01:14 ANR8944E Hardware or media error on drive DRIVE1
(mt2.0.0.2) (OP=LOCATE, Error Number=23, CC=0, KEY=03,
ASC=14, ASCQ=00,
And repeats itself, same drive same volume.
If this was a scratch volume then i think there is a solution for it because i've read
something about TSM still trying to use a scratch tape with media faults because it
cannot mark scratch tapes damaged.
Problem here is that is is a tape with data (q libv status) and i'm not sure how to
fix this problem.
Can anyone shed some light on this?
Thanks in advance,
Klaas Talsma
--
Bell Microproducts Europe BV
This message is intended only for the use of the person(s) (\"the intended
recipient(s)\") to whom it is addressed. It may contain information which is
privileged and confidential within the meaning of applicable law. If you are not the
intended recipient, please contact the sender as soon as possible. The views
expressed in this communication may not necessarily be the views held by Bell
Microproducts Europe BV.
