We found when we changed the library config (only logically) they told us to re-configure, library defs, drives and paths but we didn't need to.
We did need to run the 'update library serial=autodetect' to get it to find it's new serial number as it is somehow linked to the slot number or numbers??? Hope you get it resolved soon! Jane. -----Original Message----- From: ADSM: Dist Stor Manager [mailto:[EMAIL PROTECTED] On Behalf Of BEYERS Kurt Sent: 01 August 2007 08:30 To: [email protected] Subject: Re: [ADSM-L] Extend library capacity Thanks for the answers. I was afraid that a redefinition of the library would be the answer. Otherwise I'll give it a go as soon as TSM is finished with it's daily maintenance tasks. Which will keep him busy for a few more hours. I've opened a PMR at IBM too, maybe they come up with something else while TSM is busy. Regards, Kurt > -----Oorspronkelijk bericht----- > Van: ADSM: Dist Stor Manager [mailto:[EMAIL PROTECTED] Namens Wanda > Prather > Verzonden: dinsdag 31 juli 2007 18:11 > Aan: [email protected] > Onderwerp: Re: [ADSM-L] Extend library capacity > > The document you reference is peculiar. It says the "server may have to > be restarted or the library audited or possibly redefined", but it doesn't > make clear the cases where it needs to be redefined. > > AFAIK, when you change the number of slots in a TSM SCSI library, you have > to delete the library and drive definitions and redefine them. > > Here's what I think you need to do: > > Check out your tapes with REMOVE=NO > Make a copy of your DEVCONFIG file > Delete your paths > delete your drives > delete your library > Use the commands in the copy of your DEVCONFIG file to recreate the > library and drive and path definitions. (leave the SERIAL # off the > define drive command, let TSM figure it out.) TSM will pick up the new > slots. > > CheCK YOUR tapes back in. > (You can make it easier by running a checkin for ALL tapes (search=yes) as > STATUS=SCRATch. TSM will skip those that shouldn't be scratch. Then run > a second checkin for all tapes status=PRIVATE. > > Anybody got a different opinion? > > Wanda > > > > > > > > > > Hello, > > > > I've got the following setup: > > > > TSM server 5.4.0.3 on AIX5.3 TL5 (Extended Edition) > > Adic i2000 library > > > > The capacity of the library was extended from 500 to 600 slots by > > adding a license key. TSM was restarted afterwards and an audit of the > > ibrary was done , but TSM still only saw 500 instead of 600 slots. > > According to the following note, this is all that should be done: > > > > http://www-1.ibm.com/support/docview.wss?%20%20%20%20%20rs=663&context=S > > SGSG7&dc=D600&dc=DB520&dc=DB530&dc=D700&dc=DB500&dc=DB540&dc=DB510&dc=DB > > 550&q1=library+AND+change&uid=swg21203271&loc=en_US&cs=utf-8&lang=en > > > > The library and TSM server were rebooted too, but TSM still only sees > > 500 slots instead of 600 slots. > > > > What else should be done so that TSM detects the new added library > > slots? > > > > Thanks in advance, > > Kurt > > > > *** Disclaimer *** > > > > Vlaamse Radio- en Televisieomroep > > Auguste Reyerslaan 52, 1043 Brussel > > > > nv van publiek recht > > BTW BE 0244.142.664 > > RPR Brussel > > http://www.vrt.be/disclaimer > > > > *** Disclaimer *** Vlaamse Radio- en Televisieomroep Auguste Reyerslaan 52, 1043 Brussel nv van publiek recht BTW BE 0244.142.664 RPR Brussel http://www.vrt.be/disclaimer Please check that this email is addressed to you. If not, you should delete it immediately as its contents may be confidential and its disclosure, copying or distribution unlawful. C. & J. Clark International Limited takes steps to prevent the transmission of electronic viruses but responsibility for screening incoming messages and the risk of such transmission lies with the recipient. C. & J. Clark International Limited Trading as Clarks Registered in England number 141015. Registered office 40 High Street, Street, Somerset. BA16 0EQ. England. This message has been scanned for viruses by BlackSpider MailControl - www.blackspider.com
