You drive them in with a linemans hammer. The pole should have been pre-drilled for steps.
From: Steve Jones Sent: Monday, July 23, 2018 4:41 PM To: AnimalFarm Microwave Users Group Subject: [AFMUG] Utility pole climbing pegs We have a customer who put up a utility pole. We installed to it with a bucket truck they hired. They were supposed to either have a lift available any time we needed to service it or have climbing pegs installed. Last week we had a handful of outages I needed to work through that day including them. They kept demanding an exact time we would be there since they would be paying by the hour. Best I could tell them was sometime that afternoon as I was working my way down the map. Finally I had them just tell him to have the electrician just install the pegs and it wouldn't be an issue. I don't know how these are supposed to be installed, but I know 24 inches (48 between same side gapped pegs) has got to be too much. I'm 6 foot and could barely make the stretch on a couple of them. What's the right amount? We updated their account that this has to be fixed before we climb it again. I went ahead and climbed and fixed the issue (pole dried and shrunk enough to gap the mtow chain mount) -------------------------------------------------------------------------------- -- AF mailing list [email protected] http://af.afmug.com/mailman/listinfo/af_af.afmug.com
-- AF mailing list [email protected] http://af.afmug.com/mailman/listinfo/af_af.afmug.com
