I suppose that's the version you get when you have to get them same day.


On 7/23/2018 8:24 PM, Steve Jones wrote:
these https://www.amazon.com/Hillman-964615-8-Inch-Stainless-10-Pack/dp/B003VG0YBK/ref=asc_df_B003VG0YBK/?tag=hyprod-20&linkCode=df0&hvadid=167121478040&hvpos=1o5&hvnetw=g&hvrand=15747788179264552478&hvpone=&hvptwo=&hvqmt=&hvdev=c&hvdvcmdl=&hvlocint=&hvlocphy=9022172&hvtargid=pla-313284598686&psc=1

On Mon, Jul 23, 2018 at 6:09 PM <[email protected] <mailto:[email protected]>> wrote:

    
https://www.elvessupply.com/Hubbell-Power-506125-Drive-Hook-Step_p_1888971.html?gclid=EAIaIQobChMIrMDumKu23AIVT2B-Ch2Vkww7EAQYAyABEgLmK_D_BwE
    Not spaced more than 18 inches, 36 inches on one side.
    Lowest permanent step 6 feet off the ground with detachable steps
    from 24 inches up to that level.
    https://www.macleanpower.com/products/item.asp?ITEM_ID=2197
    *From:* Steve Jones
    *Sent:* Monday, July 23, 2018 5:02 PM
    *To:* AnimalFarm Microwave Users Group
    *Subject:* Re: [AFMUG] Utility pole climbing pegs
    half of these are lag screws
    On Mon, Jul 23, 2018 at 5:57 PM <[email protected]> wrote:

        You drive them in with a linemans hammer.
        The pole should have been pre-drilled for steps.
        *From:* Steve Jones
        *Sent:* Monday, July 23, 2018 4:41 PM
        *To:* AnimalFarm Microwave Users Group
        *Subject:* [AFMUG] Utility pole climbing pegs
        We have a customer who put up a utility pole. We installed to
        it with a bucket truck they hired. They were supposed to
        either have a lift available any time we needed to service it
        or have climbing pegs installed. Last week we had a handful of
        outages I needed to work through that day including them. They
        kept demanding an exact time we would be there since they
        would be paying by the hour.  Best I could tell them was
        sometime that afternoon as I was working my way down the map.
        Finally I had them just tell him to have the electrician just
        install the pegs and it wouldn't be an issue.
        I don't know how these are supposed to be installed, but I
        know 24 inches (48 between same side gapped pegs) has got to
        be too much. I'm 6 foot and could barely make the stretch on a
        couple of them.
        What's the right amount? We updated their account that this
        has to be fixed before we climb it again. I went ahead and
        climbed and fixed the issue (pole dried and shrunk enough to
        gap the mtow chain mount)

        ------------------------------------------------------------------------
-- AF mailing list
        [email protected]
        http://af.afmug.com/mailman/listinfo/af_af.afmug.com
-- AF mailing list
        [email protected]
        http://af.afmug.com/mailman/listinfo/af_af.afmug.com

    ------------------------------------------------------------------------
-- AF mailing list
    [email protected] <mailto:[email protected]>
    http://af.afmug.com/mailman/listinfo/af_af.afmug.com
-- AF mailing list
    [email protected] <mailto:[email protected]>
    http://af.afmug.com/mailman/listinfo/af_af.afmug.com




-- 
AF mailing list
[email protected]
http://af.afmug.com/mailman/listinfo/af_af.afmug.com

Reply via email to