thats what i figured, they had a few on hand but needed more and thats why its mixed matched. Also I figured since theyre not very common anymore thats why theyre installed too far apart, the guy just didnt know. Theyre also not 180 degrees from each other, maybe 120 degrees, is that normal?
On Mon, Jul 23, 2018 at 9:18 PM Adam Moffett <[email protected]> wrote: > I suppose that's the version you get when you have to get them same day. > > > On 7/23/2018 8:24 PM, Steve Jones wrote: > > these > https://www.amazon.com/Hillman-964615-8-Inch-Stainless-10-Pack/dp/B003VG0YBK/ref=asc_df_B003VG0YBK/?tag=hyprod-20&linkCode=df0&hvadid=167121478040&hvpos=1o5&hvnetw=g&hvrand=15747788179264552478&hvpone=&hvptwo=&hvqmt=&hvdev=c&hvdvcmdl=&hvlocint=&hvlocphy=9022172&hvtargid=pla-313284598686&psc=1 > > On Mon, Jul 23, 2018 at 6:09 PM <[email protected]> wrote: > >> >> https://www.elvessupply.com/Hubbell-Power-506125-Drive-Hook-Step_p_1888971.html?gclid=EAIaIQobChMIrMDumKu23AIVT2B-Ch2Vkww7EAQYAyABEgLmK_D_BwE >> >> Not spaced more than 18 inches, 36 inches on one side. >> >> Lowest permanent step 6 feet off the ground with detachable steps from 24 >> inches up to that level. >> >> https://www.macleanpower.com/products/item.asp?ITEM_ID=2197 >> >> *From:* Steve Jones >> *Sent:* Monday, July 23, 2018 5:02 PM >> *To:* AnimalFarm Microwave Users Group >> *Subject:* Re: [AFMUG] Utility pole climbing pegs >> >> half of these are lag screws >> >> On Mon, Jul 23, 2018 at 5:57 PM <[email protected]> wrote: >> >>> You drive them in with a linemans hammer. >>> The pole should have been pre-drilled for steps. >>> >>> *From:* Steve Jones >>> *Sent:* Monday, July 23, 2018 4:41 PM >>> *To:* AnimalFarm Microwave Users Group >>> *Subject:* [AFMUG] Utility pole climbing pegs >>> >>> We have a customer who put up a utility pole. We installed to it with a >>> bucket truck they hired. They were supposed to either have a lift available >>> any time we needed to service it or have climbing pegs installed. Last week >>> we had a handful of outages I needed to work through that day including >>> them. They kept demanding an exact time we would be there since they would >>> be paying by the hour. Best I could tell them was sometime that afternoon >>> as I was working my way down the map. Finally I had them just tell him to >>> have the electrician just install the pegs and it wouldn't be an issue. >>> >>> I don't know how these are supposed to be installed, but I know 24 >>> inches (48 between same side gapped pegs) has got to be too much. I'm 6 >>> foot and could barely make the stretch on a couple of them. >>> >>> What's the right amount? We updated their account that this has to be >>> fixed before we climb it again. I went ahead and climbed and fixed the >>> issue (pole dried and shrunk enough to gap the mtow chain mount) >>> >>> ------------------------------ >>> -- >>> AF mailing list >>> [email protected] >>> http://af.afmug.com/mailman/listinfo/af_af.afmug.com >>> -- >>> AF mailing list >>> [email protected] >>> http://af.afmug.com/mailman/listinfo/af_af.afmug.com >>> >> ------------------------------ >> -- >> AF mailing list >> [email protected] >> http://af.afmug.com/mailman/listinfo/af_af.afmug.com >> -- >> AF mailing list >> [email protected] >> http://af.afmug.com/mailman/listinfo/af_af.afmug.com >> > > > > -- > AF mailing list > [email protected] > http://af.afmug.com/mailman/listinfo/af_af.afmug.com >
-- AF mailing list [email protected] http://af.afmug.com/mailman/listinfo/af_af.afmug.com
