Do you guys ground all your base radios?
Yes.
Do you use surge suppressors?
I've done it both ways. Currently yes, but only at the bottom.
Do you use shielded cable on the towers with metal ends?
Yes
Do you put all your cable in conduit going up the tower?
Depends. We have some that are highly visible, and conduit keeps them
looking cleaner than a bundle of zip tied cables would. The point about
long vertical hanging is valid, but there are ways to mitigate that:
You can add boxes with grips in the middle, or you can stuff the conduit
so full that the cables can't move. Laugh if you want to, but I promise
you that works. On shortish towers I don't even worry about it. We
have more than twenty 70' high poles with CAT5, fiber, and DC power
secured at the top, but otherwise hanging freely in a vertical 2"
conduit. Zero problems.
I'll disagree with the idea that replacing one cable is harder. You
just use the bad cable to pull in the good one. If you have grips in
the middle, then stop at each box and pull it at each one. If you have
a bundle zip tied up a tower leg you have to cut and replace zip ties
the whole way up the tower. There's no way that's faster. And let's be
real here, when you're zip tying those cables up you're probably just
adding in a new good cable and leaving the old one there forever because
it's too much hassle to get it out of the bundle.
IMO The replacement question is moot anyway....why are you replacing
cables? Probably they got water in them. Why did they get water in
them? Because someone stomped it with their boot, banged a toolbag into
it, nicked it when cutting a zip tie, a bird or squirrel picked at it,
or it rubbed on sharp edge. I.E.: Physical damage which would have been
prevented by the conduit. I'm not an evangelist on this topic, and we
have plenty of cables that are just zip tied up a structure, but I do
believe conduit is better.
You could also use a ladder and snap-ins like Daniel White suggested.
They make blocks with holes for multiple CAT5 cables. I never went down
that road only because it seemed to add up to a lot of $ when you figure
up what all the little parts cost. It sounds like a good way in principle.
Do you use steel cable ties?
No
Do you put some kind of grease or spray on the cat5 end before you set
in place?
No, but nor do I object to the practice.
Do you use stainless steel guy wires?
Stainless never occurred to me. I didn't know that was an option.
Structural steel has higher tensile strength than stainless, and hot dip
galvanized isn't going to rust in your lifetime unless you've got a
galvanic corrosion thing going on.
-Adam
--
AF mailing list
[email protected]
http://af.afmug.com/mailman/listinfo/af_af.afmug.com
