I had an EPMP3000 AP on a tower that died after a web page initiated
reboot. I got it swapped out and when I put it on the bench, accessing
on 169.254.1.1 loaded a page saying to 'Load Firmware' With a big
disclaimer saying 'No Firmware validation done, make sure you load a
proper image'
I loaded the 4.6.1 firmware on it, and it appears to be booting normally
now. I'm concerned to deploy it again, since 'something' happened, but
why wouldn't it have loaded the backup firmware if the primary was
corrupted? Anyone run into this before? The AP was acting up which is
what prompted the initial reboot. 2 Sm's next to each other on a roof,
one SM had 70% packet loss, the Other SM had 0% packet loss. Only thing
that hadn't been rebooted yet was the AP.
--
AF mailing list
[email protected]
http://af.afmug.com/mailman/listinfo/af_af.afmug.com
