Was yours acting up before the issue? This AP had been slowly loosing
TX power for about 2 months.
On 1/2/2024 12:38 PM, Steve Jones wrote:
I had this issue once. I dont recall an RMA. It probably ended up
deployed again close by in case of further issue then forgot about. I
do remember loading multiple firmwares in both banks multiple times to
make sure nothing collapsed
On Thu, Dec 21, 2023 at 4:55 PM Nate Burke <[email protected]> wrote:
I had an EPMP3000 AP on a tower that died after a web page initiated
reboot. I got it swapped out and when I put it on the bench,
accessing
on 169.254.1.1 loaded a page saying to 'Load Firmware' With a big
disclaimer saying 'No Firmware validation done, make sure you load a
proper image'
I loaded the 4.6.1 firmware on it, and it appears to be booting
normally
now. I'm concerned to deploy it again, since 'something'
happened, but
why wouldn't it have loaded the backup firmware if the primary was
corrupted? Anyone run into this before? The AP was acting up
which is
what prompted the initial reboot. 2 Sm's next to each other on a
roof,
one SM had 70% packet loss, the Other SM had 0% packet loss. Only
thing
that hadn't been rebooted yet was the AP.
--
AF mailing list
[email protected]
http://af.afmug.com/mailman/listinfo/af_af.afmug.com
--
AF mailing list
[email protected]
http://af.afmug.com/mailman/listinfo/af_af.afmug.com
