There was something that cause me to poke at it, but it was years ago. I just remember the screen was odd to see
On Tue, Jan 2, 2024 at 1:21 PM Nate Burke <[email protected]> wrote: > Was yours acting up before the issue? This AP had been slowly loosing TX > power for about 2 months. > On 1/2/2024 12:38 PM, Steve Jones wrote: > > I had this issue once. I dont recall an RMA. It probably ended up deployed > again close by in case of further issue then forgot about. I do remember > loading multiple firmwares in both banks multiple times to make sure > nothing collapsed > > On Thu, Dec 21, 2023 at 4:55 PM Nate Burke <[email protected]> wrote: > >> I had an EPMP3000 AP on a tower that died after a web page initiated >> reboot. I got it swapped out and when I put it on the bench, accessing >> on 169.254.1.1 loaded a page saying to 'Load Firmware' With a big >> disclaimer saying 'No Firmware validation done, make sure you load a >> proper image' >> >> I loaded the 4.6.1 firmware on it, and it appears to be booting normally >> now. I'm concerned to deploy it again, since 'something' happened, but >> why wouldn't it have loaded the backup firmware if the primary was >> corrupted? Anyone run into this before? The AP was acting up which is >> what prompted the initial reboot. 2 Sm's next to each other on a roof, >> one SM had 70% packet loss, the Other SM had 0% packet loss. Only thing >> that hadn't been rebooted yet was the AP. >> >> >> -- >> AF mailing list >> [email protected] >> http://af.afmug.com/mailman/listinfo/af_af.afmug.com >> > > -- > AF mailing list > [email protected] > http://af.afmug.com/mailman/listinfo/af_af.afmug.com >
-- AF mailing list [email protected] http://af.afmug.com/mailman/listinfo/af_af.afmug.com
